Projects / Ideas / Resettable fuse trip lab

Resettable fuse trip lab

BeginnerPowerIdeaReviewed
In short

How do you build a resettable fuse trip lab?

Put a 500 mA resettable fuse in series with a cell pack and a few resistors, and measure what current it holds and when it trips, then see how long it takes to recover. It shows the hold and trip numbers on the data sheet in real life. The fuse and resistors warm up, so keep the tests short and on a heatproof surface. You need Polyfuse (PTC resettable) 500 mA, Wirewound resistor 1 Ω 10 W, Resistor 10 Ω, Resistor 47 Ω, Battery holder 4 × AA with switch, AA alkaline battery × 4 and Digital multimeter.

Level
Beginner
Time
About 60 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See a resettable fuse trip and recover.

How to build it

  1. Read the hold and trip currents
  2. Wire the fuse in series with a large resistor
  3. Add a lower resistor to push the current up
  4. Measure the current and voltage across the fuse
  5. Time how long it takes to reset

Related projects

Common questions

What parts do I need for the resettable fuse trip lab?

Polyfuse (PTC resettable) 500 mA, Wirewound resistor 1 Ω 10 W, Resistor 10 Ω, Resistor 47 Ω, Battery holder 4 × AA with switch, AA alkaline battery × 4 and Digital multimeter.

How long does the resettable fuse trip lab take to build?

About 60 minutes for a beginner maker.