Idea
In short
How do you build an AA cell series and parallel pack lab?
Build a two-cell and a four-cell pack in series and a pair in parallel, then measure open voltage and the voltage under a resistor load. You learn why series adds volts, parallel adds staying power, and why mixed old and new cells are a bad idea. You need Battery holder 2 × AA, Battery holder 4 × AA with switch, AA alkaline battery × 4, Resistor 100 Ω, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 45 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure how cells add up before you build a battery box.
Parts list
- Power
- Power
- Batteries
- Passives
- Passives
- Prototyping
- Prototyping
How to build it
- Measure one fresh cell with no load
- Measure the two-cell holder and the four-cell holder
- Add a resistor load and measure again
- Wire two cells in parallel and compare
- Write a one-page rule for choosing a holder
Common questions
What parts do I need for the AA cell series and parallel pack lab?
Battery holder 2 × AA, Battery holder 4 × AA with switch, AA alkaline battery × 4, Resistor 100 Ω, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the AA cell series and parallel pack lab take to build?
About 45 minutes for a beginner maker.
