Projects / Ideas / Signal isolator with an optocoupler

Signal isolator with an optocoupler

IntermediateDigital LogicIdeaReviewed
In short

How do you build a signal isolator with an optocoupler?

An optocoupler passes a logic signal between two separate supplies without a shared ground. You need Optocoupler PC817, Resistor 1 kΩ, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, 9 V battery and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 120 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Isolate a signal between two circuits at low voltage.

Parts list

How to build it

  1. Wire the LED side with a resistor
  2. Wire the output transistor side
  3. Pass a signal across
  4. Measure the delay
  5. Discuss where isolation is needed

Related projects

Common questions

What parts do I need for the signal isolator with an optocoupler?

Optocoupler PC817, Resistor 1 kΩ, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, 9 V battery and Breadboard 830 Tie Points.

How long does the signal isolator with an optocoupler take to build?

About 120 minutes for a intermediate maker.