Projects / Ideas / Nucleo low-power stop mode

Nucleo low-power stop mode

IntermediatePowerIdeaReviewed
In short

How do you build a nucleo low-power stop mode?

A Nucleo board sleeps in stop mode and wakes on a button press to flash an LED, then sleeps again. Compare the supply current in run and stop mode with a multimeter in its milliamp range. You need STM32 Nucleo-64, Tactile push button 6 mm, Resistor 10 kΩ and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 150 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See how much current a sleeping microcontroller saves.

Parts list

How to build it

  1. Set the button pin as an external interrupt
  2. Enter stop mode with the wait-for-interrupt call
  3. Wake, flash the LED, then sleep again
  4. Remove unused clocks and set idle pins as analog
  5. Measure the supply current in both modes

Related projects

Common questions

What parts do I need for the nucleo low-power stop mode?

STM32 Nucleo-64, Tactile push button 6 mm, Resistor 10 kΩ and Breadboard 830 Tie Points.

How long does the nucleo low-power stop mode take to build?

About 150 minutes for a intermediate maker.