Idea
In short
How do you build an HMI touch panel for lights?
A touchscreen sends button presses to a board that switches four low-voltage LED outputs. You need Arduino Nano, Nextion 3.5 inch HMI display, MOSFET IRLZ44N × 4, Resistor 10 kΩ × 4 and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 330 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a serial HMI display for a control panel.
Parts list
- Development Boards
- Displays
- SemiconductorsMOSFET IRLZ44N × 4
- PassivesResistor 10 kΩ × 4
- Prototyping
How to build it
- Design the screen in the editor
- Send commands over serial
- Read touch events
- Switch the four outputs
- Show the state
Common questions
What parts do I need for the HMI touch panel for lights?
Arduino Nano, Nextion 3.5 inch HMI display, MOSFET IRLZ44N × 4, Resistor 10 kΩ × 4 and Breadboard 830 Tie Points.
How long does the HMI touch panel for lights take to build?
About 330 minutes for a intermediate maker.
