Projects / Ideas / Nano Type-C first upload lab

Nano Type-C first upload lab

BeginnerLearningIdeaReviewed
In short

How do you build a nano Type-C first upload lab?

A Nano clone with a Type-C port and a CH340 chip needs the right driver and board settings before the first upload. Install the driver, pick the Old Bootloader if needed, and blink an LED, then keep a short checklist for the next clone. You need Arduino Nano (CH340, Type-C), LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 40 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Get a new Nano clone talking to your computer.

How to build it

  1. Plug in a data USB-C cable
  2. Install the CH340 driver if needed
  3. Choose the Nano board and port
  4. Try the Old Bootloader option
  5. Blink an LED and write your checklist

Related projects

Common questions

What parts do I need for the nano Type-C first upload lab?

Arduino Nano (CH340, Type-C), LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the nano Type-C first upload lab take to build?

About 40 minutes for a beginner maker.