Projects / Ideas / BeagleBone PRU real-time LED

BeagleBone PRU real-time LED

AdvancedLearningIdeaReviewed
In short

How do you build a beagleBone PRU real-time LED?

Use the BeagleBone's real-time units to make exact pulses that Linux alone cannot. You need BeagleBone Black, Resistor 220 Ω, LED 5 mm red, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Advanced
Time
About 300 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Use real-time hardware inside a Linux board.

Parts list

How to build it

  1. Boot and connect
  2. Enable the PRU
  3. Write a PRU program
  4. Make a precise waveform
  5. Compare with a Linux GPIO toggle

Related projects

Common questions

What parts do I need for the beagleBone PRU real-time LED?

BeagleBone Black, Resistor 220 Ω, LED 5 mm red, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the beagleBone PRU real-time LED take to build?

About 300 minutes for a advanced maker.