Projects / Ideas / Wardrobe dehumidifier controller

Wardrobe dehumidifier controller

IntermediateSmart HomeIdeaReviewed
In short

How do you build a wardrobe dehumidifier controller?

A humidity sensor in a wardrobe switches on a small fan and a resistor heater in monsoon to keep clothes from smelling of mould. You need Arduino Nano, AHT20 temperature and humidity sensor, Relay module 2-channel 5 V, 5 V DC fan 40 mm, Power resistor 10 Ω 5 W (cement), 12 V 2 A DC adapter, LM2596 Buck Module and Thermal fuse 72 °C.

Level
Intermediate
Time
About 120 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Control two loads with hysteresis and a timer limit for safety.

How to build it

  1. Mount the sensor at mid-height in the wardrobe
  2. Switch the fan on above 65 % and off below 55 %
  3. Add the warm resistor only when humidity stays high for an hour
  4. Put a 72 °C thermal fuse in series with the resistor
  5. Limit the heater to 30 minutes in each hour

Related projects

Common questions

What parts do I need for the wardrobe dehumidifier controller?

Arduino Nano, AHT20 temperature and humidity sensor, Relay module 2-channel 5 V, 5 V DC fan 40 mm, Power resistor 10 Ω 5 W (cement), 12 V 2 A DC adapter, LM2596 Buck Module and Thermal fuse 72 °C.

How long does the wardrobe dehumidifier controller take to build?

About 120 minutes for a intermediate maker.