How do you build a model windmill with a rev counter?
A small motor turns the sails of a model windmill at a speed set by a knob, while a reflective sensor counts the turns and the screen shows revolutions per minute. A friendly way to see how motor speed, PWM and counting fit together. Keep fingers and hair away from the sails. You need Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, TCRT5000 IR reflective sensor module, Potentiometer 10 kΩ, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 100 min
- Parts
- 8
Spin model sails and count their turns.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Sensors
- Passives
- Displays
- Prototyping
- Prototyping
How to build it
- Wire the motor driver and the sensor
- Set the speed with the knob
- Mark one sail with reflective tape
- Count passes to get turns per minute
- Show the speed on the screen
Related projects
Common questions
What parts do I need for the model windmill with a rev counter?
Arduino Nano, DC motor 130 size (toy motor), TB6612FNG Motor Driver, TCRT5000 IR reflective sensor module, Potentiometer 10 kΩ, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the model windmill with a rev counter take to build?
About 100 minutes for a intermediate maker.
