Projects / Ideas / L298N chip H-bridge bench

L298N chip H-bridge bench

IntermediateMotionIdeaReviewed
In short

How do you build an L298N chip H-bridge bench?

Use the bare L298N chip rather than a module: wire the supply, logic, enable and sense pins, add four fast diodes across the outputs, and drive a small motor forward, back and at different speeds from a Nano. It shows what the ready-made modules hide. You need Arduino Nano, L298N motor driver IC, DC motor 130 size (toy motor), Rectifier Diode 1N4007 × 4, Potentiometer 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 120 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Drive a small motor from the bare driver chip.

Parts list

How to build it

  1. Read the datasheet pin table
  2. Wire the chip supplies and the Nano inputs
  3. Add the four diodes across the outputs
  4. Drive forward and back
  5. Use PWM on the enable pin and test a pot speed knob

Related projects

Common questions

What parts do I need for the L298N chip H-bridge bench?

Arduino Nano, L298N motor driver IC, DC motor 130 size (toy motor), Rectifier Diode 1N4007 × 4, Potentiometer 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the L298N chip H-bridge bench take to build?

About 120 minutes for a intermediate maker.