Idea
In short
How do you build a measuring wheel odometer?
A wheel on a rotary encoder rolls along a table or a wall and the screen shows the distance in centimetres. A button resets the count. A good project for turning pulses into units and checking the result against a tape measure. You need Arduino Nano, Rotary encoder module (KY-040), SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 80 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure a length by rolling a wheel.
Parts list
- Development Boards
- Sensors
- Displays
- Switches
- Prototyping
- Prototyping
How to build it
- Fit a wheel of known size to the encoder
- Count the encoder pulses
- Convert pulses to centimetres
- Show the distance on the screen
- Calibrate it against a tape measure
Related projects
Common questions
What parts do I need for the measuring wheel odometer?
Arduino Nano, Rotary encoder module (KY-040), SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the measuring wheel odometer take to build?
About 80 minutes for a beginner maker.
