Projects / Ideas / Load cell creep and drift lab

Load cell creep and drift lab

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a load cell creep and drift lab?

Leave a steady weight on a bar load cell for an hour and log the reading, then take the weight off and see where zero went. The slow creep and the warm-up drift are why good scales wait a moment before they show a number. You need Arduino Nano, HX711 load cell amplifier, Load cell 5 kg (bar type), MicroSD Card Module, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Watch a load cell creep and drift over an hour.

How to build it

  1. Calibrate with a known weight
  2. Log the reading every ten seconds
  3. Leave the weight for an hour
  4. Remove it and log the zero
  5. Chart the creep and the drift

Related projects

Common questions

What parts do I need for the load cell creep and drift lab?

Arduino Nano, HX711 load cell amplifier, Load cell 5 kg (bar type), MicroSD Card Module, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the load cell creep and drift lab take to build?

About 90 minutes for a intermediate maker.