Projects / Ideas / Humidity salt test calibration

Humidity salt test calibration

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a humidity salt test calibration?

Seal three humidity sensors in a jar with a saucer of damp table salt, which settles at about 75 percent humidity, and compare what they read after a day. It is the classic home test for a humidity sensor, and shows which one reads high or low. You need Arduino Nano, AHT10 temperature and humidity sensor, DHT22 Sensor, BME280 Environmental Sensor, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Check three humidity sensors against a known value.

How to build it

  1. Wire the three sensors
  2. Show all three on the display
  3. Seal them in a jar with damp salt
  4. Wait a day and note the readings
  5. Work out each sensor's offset

Related projects

Common questions

What parts do I need for the humidity salt test calibration?

Arduino Nano, AHT10 temperature and humidity sensor, DHT22 Sensor, BME280 Environmental Sensor, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the humidity salt test calibration take to build?

About 100 minutes for a intermediate maker.