Idea
In short
How do you build a borewell water level meter?
A submersible pressure sensor lowered into a borewell measures the water column above it to show how far the water table moves through the year. You need ESP32 DevKit V1, Water pressure sensor (0 to 1.2 MPa), ADS1115 16-bit ADC module, Multi-core shielded cable 4-core, MicroSD Card Module and DS3231 RTC module.
- Level
- Advanced
- Time
- About 300 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Turn a pressure reading into water depth and log it over months.
Parts list
- Development Boards
- Sensors
- Sensors
- Cables & Wires
- Interfaces
- Sensors
How to build it
- Seal the sensor and cable for submersion
- Read it with the 16-bit ADC for fine resolution
- Depth of water above the sensor = pressure ÷ (density × g)
- Lower to a known depth and calibrate
- Log daily at dawn before pumping starts
Related projects
Common questions
What parts do I need for the borewell water level meter?
ESP32 DevKit V1, Water pressure sensor (0 to 1.2 MPa), ADS1115 16-bit ADC module, Multi-core shielded cable 4-core, MicroSD Card Module and DS3231 RTC module.
How long does the borewell water level meter take to build?
About 300 minutes for a advanced maker.
