Idea
In short
How do you build a gesture-controlled small fan?
Wave left or right over a sensor to speed up or slow down a small 5 V fan. You need Arduino Nano, APDS-9960 gesture, colour and proximity sensor, MOSFET IRLZ44N, Rectifier Diode 1N4007, Resistor 10 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a gesture sensor to control a motor.
Parts list
- Development Boards
- Sensors
- Semiconductors
- Semiconductors
- Passives
- Prototyping
How to build it
- Read gestures over I2C
- Map up and down to speed
- Drive the fan through a MOSFET
- Add a flyback diode
- Show the speed level on serial
Common questions
What parts do I need for the gesture-controlled small fan?
Arduino Nano, APDS-9960 gesture, colour and proximity sensor, MOSFET IRLZ44N, Rectifier Diode 1N4007, Resistor 10 kΩ and Breadboard 830 Tie Points.
How long does the gesture-controlled small fan take to build?
About 210 minutes for a intermediate maker.
