Projects / Ideas / Six-position accelerometer calibration

Six-position accelerometer calibration

IntermediateSensorsIdeaReviewed
In short

How do you build a six-position accelerometer calibration?

Rest an ADXL345 on each of its six faces and read the three axes, then work out the offset and scale of each axis from the plus and minus one g readings. It is the standard way to calibrate a tilt sensor with nothing but a flat table. You need Arduino Nano, ADXL345 accelerometer, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Calibrate a tilt sensor with six resting positions.

How to build it

  1. Wire the sensor and display
  2. Rest the sensor flat on each of six faces
  3. Record each axis reading
  4. Work out offset and scale per axis
  5. Apply them and check with a level table

Related projects

Common questions

What parts do I need for the six-position accelerometer calibration?

Arduino Nano, ADXL345 accelerometer, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the six-position accelerometer calibration take to build?

About 90 minutes for a intermediate maker.