Projects / Ideas / Grip trend trainer

Grip trend trainer

IntermediateHealthIdeaReviewed
In short

How do you build a grip trend trainer?

A force-sensitive resistor under a squeeze pad measures how hard you squeeze, and a Nano shows the peak and a weekly trend on an OLED. It is for fun training only and is not a medical or rehabilitation device. You need Arduino Nano, Force sensitive resistor FSR 402, Resistor 10 kΩ, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 110 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Track a squeeze exercise over time.

How to build it

  1. Wire the force sensor as a divider
  2. Calibrate against known weights
  3. Record the peak of each squeeze
  4. Store a short history in memory
  5. Draw a small bar chart

Related projects

Common questions

What parts do I need for the grip trend trainer?

Arduino Nano, Force sensitive resistor FSR 402, Resistor 10 kΩ, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the grip trend trainer take to build?

About 110 minutes for a intermediate maker.