Idea
In short
How do you build a finger-bend meter?
A flex sensor on a glove finger shows how far the finger is bent, a first step toward gesture and rehabilitation tools. Learning only; not a medical device. You need Arduino Nano, Flex sensor 2.2 inch, Resistor 10 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure bending with a flex sensor.
Parts list
- Development Boards
- Sensors
- Passives
- Displays
- Prototyping
How to build it
- Wire the flex sensor in a divider
- Read the value
- Calibrate flat and fully bent
- Show an angle estimate
- Add a threshold beep
Common questions
What parts do I need for the finger-bend meter?
Arduino Nano, Flex sensor 2.2 inch, Resistor 10 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.
How long does the finger-bend meter take to build?
About 150 minutes for a beginner maker.
