Projects / Ideas / ESP32-S3 dust monitor

ESP32-S3 dust monitor

IntermediateEnvironmentIdeaReviewed
In short

How do you build an ESP32-S3 dust monitor?

An ESP32-S3 reads a PMS5003 particulate sensor over serial and shows PM2.5 on a page and an OLED. Readings are indicative only and not a health or compliance measurement. You need ESP32-S3 DevKitC-1, PMS5003 particulate matter sensor, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 160 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Watch indoor dust levels.

How to build it

  1. Power the sensor from 5 V
  2. Read the serial frames
  3. Check the frame checksum
  4. Show PM1.0, PM2.5 and PM10
  5. Log values on the local page

Related projects

Common questions

What parts do I need for the ESP32-S3 dust monitor?

ESP32-S3 DevKitC-1, PMS5003 particulate matter sensor, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the ESP32-S3 dust monitor take to build?

About 160 minutes for a intermediate maker.