Projects / Ideas / ESP32 AA battery tester

ESP32 AA battery tester

IntermediatePowerIdeaReviewed
In short

How do you build an ESP32 AA battery tester?

An ESP32 with an INA219 measures a fresh or used AA cell discharging through a load resistor and plots its voltage over time on a local page. Discharge only: never charge cells this way, and use a resistor rated for the power. You need ESP32 DevKit V1, INA219 Current Monitor, Resistor 10 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 170 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See how much life is left in an AA cell.

How to build it

  1. Choose a load resistor and check its power rating
  2. Wire the sensor in the load path
  3. Log voltage and current each minute
  4. Show the cut-off voltage
  5. Show the capacity estimate

Related projects

Common questions

What parts do I need for the ESP32 AA battery tester?

ESP32 DevKit V1, INA219 Current Monitor, Resistor 10 kΩ, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the ESP32 AA battery tester take to build?

About 170 minutes for a intermediate maker.