Idea
In short
How do you build an ESP32 doorbell button with a chime?
A pair of ESP32 boards on the same network: a button board sends a short message to a chime board that plays a tune on a buzzer. Home network only. You need ESP32 DevKit V1 × 2, Tactile push button 6 mm, Passive buzzer, Resistor 330 Ω and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 160 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Send a message from a button board to a chime board.
Parts list
- Development BoardsESP32 DevKit V1 × 2
- Switches
- Motors & Actuators
- Passives
- Prototyping
How to build it
- Set up one board as a button sender
- Send a short UDP message on a press
- Listen on the second board
- Play a tune on a message
- Add a debounce and a quiet time
Common questions
What parts do I need for the ESP32 doorbell button with a chime?
ESP32 DevKit V1 × 2, Tactile push button 6 mm, Passive buzzer, Resistor 330 Ω and Breadboard 830 Tie Points.
How long does the ESP32 doorbell button with a chime take to build?
About 160 minutes for a intermediate maker.
