Idea
In short
How do you build a muscle activity bar display?
A MyoWare sensor on the forearm lights a bar of LEDs in proportion to muscle effort, a safe way to see biosignals. You need Arduino Nano, EMG muscle sensor (MyoWare 2.0), LM3914 bar graph driver, LED 5 mm red × 10 and Resistor 330 Ω.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Rectify and smooth a muscle signal for display.
Parts list
- Development Boards
- Sensors
- Integrated Circuits
- SemiconductorsLED 5 mm red × 10
- Passives
How to build it
- Place the pads on the forearm muscle
- Read the envelope output
- Smooth over 100 ms
- Drive the LED bar
- Compare a relaxed and a clenched hand
Common questions
What parts do I need for the muscle activity bar display?
Arduino Nano, EMG muscle sensor (MyoWare 2.0), LM3914 bar graph driver, LED 5 mm red × 10 and Resistor 330 Ω.
How long does the muscle activity bar display take to build?
About 120 minutes for a intermediate maker.
