Idea
In short
How do you build a three-pad piezo drum kit?
Three piezo disks sense taps and trigger different sounds on a small speaker amplifier. You need Arduino Uno R3, Active buzzer 5 V × 3, Resistor 1 kΩ × 3, PAM8403 stereo amplifier module, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Detect taps with a piezo and trigger tones.
Parts list
- Development Boards
- Motors & Actuators
- PassivesResistor 1 kΩ × 3
- Audio
- Prototyping
- Prototyping
How to build it
- Use a piezo disc as a tap sensor
- Add a resistor and clamp the voltage
- Detect peaks in software
- Play a different tone per pad
- Add a velocity-sensitive volume
Related projects
Common questions
What parts do I need for the three-pad piezo drum kit?
Arduino Uno R3, Active buzzer 5 V × 3, Resistor 1 kΩ × 3, PAM8403 stereo amplifier module, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the three-pad piezo drum kit take to build?
About 210 minutes for a intermediate maker.
