Idea
In short
How do you build a drip irrigation pump timer?
A timer runs a small 12 V pump for a few minutes each morning to water a balcony garden, with a float switch to stop if the tank is empty. You need Arduino Nano, DS3231 RTC module, Mini submersible water pump (3 to 6 V), MOSFET IRLZ44N, Rectifier Diode 1N4007, Float switch (vertical), Resistor 10 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Schedule watering and protect the pump.
Parts list
- Development Boards
- Sensors
- Motors & Actuators
- Semiconductors
- Semiconductors
- Sensors
- Passives
- Prototyping
How to build it
- Set the watering time and duration
- Drive the pump with a MOSFET
- Add a flyback diode
- Stop when the float switch shows empty
- Log each run
Common questions
What parts do I need for the drip irrigation pump timer?
Arduino Nano, DS3231 RTC module, Mini submersible water pump (3 to 6 V), MOSFET IRLZ44N, Rectifier Diode 1N4007, Float switch (vertical), Resistor 10 kΩ and Breadboard 830 Tie Points.
How long does the drip irrigation pump timer take to build?
About 210 minutes for a intermediate maker.
