Projects / Ideas / Voltage divider loading lab

Voltage divider loading lab

BeginnerAnalog CircuitsIdeaReviewed
In short

How do you build a voltage divider loading lab?

Build a 10 kΩ and 10 kΩ divider, then connect loads of different sizes across the output and measure how far the voltage sags. It shows why a divider cannot drive heavy loads and why buffers exist. You need Resistor 10 kΩ × 2, Resistor 1 kΩ, Resistor 4.7 kΩ, Resistor 100 kΩ, Resistor 47 kΩ, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 40 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See how a load pulls a divider off its set voltage.

How to build it

  1. Build the unloaded divider and note the voltage
  2. Add the 100 kΩ load and measure
  3. Try 47 kΩ, 10 kΩ and 4.7 kΩ
  4. Compare with the calculated value
  5. Redo the divider with 1 kΩ resistors to see the difference

Related projects

Common questions

What parts do I need for the voltage divider loading lab?

Resistor 10 kΩ × 2, Resistor 1 kΩ, Resistor 4.7 kΩ, Resistor 100 kΩ, Resistor 47 kΩ, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the voltage divider loading lab take to build?

About 40 minutes for a beginner maker.