Projects / Ideas / DIP switch binary resistor ladder

DIP switch binary resistor ladder

IntermediateAnalog CircuitsIdeaReviewed
In short

How do you build a DIP switch binary resistor ladder?

A DIP switch selects binary-weighted resistors in a simple summing network so you can set an output voltage in steps and read it with a multimeter. It is a hands-on way to see how a digital number becomes a voltage. You need DIP switch 8-position, Resistor 10 kΩ × 4, Resistor 22 kΩ × 4, Resistor 1 kΩ, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 60 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Turn a binary number into a voltage with switches.

How to build it

  1. Plan a four-bit summing network
  2. Wire the resistors to the DIP switch
  3. Measure the output for each of the sixteen codes
  4. Plot the steps
  5. Note where the steps are uneven and why

Related projects

Common questions

What parts do I need for the DIP switch binary resistor ladder?

DIP switch 8-position, Resistor 10 kΩ × 4, Resistor 22 kΩ × 4, Resistor 1 kΩ, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the DIP switch binary resistor ladder take to build?

About 60 minutes for a intermediate maker.