Idea
In short
How do you build a data demultiplexer?
Three select switches choose which of four output LEDs follows a data switch, using one 74HC138 chip as a demultiplexer. It is the opposite of a multiplexer, and a way to see how one signal can be sent to many places. You need 74HC138 3-to-8 decoder, Tactile push button 6 mm × 3, LED 5 mm red × 4, Resistor 220 Ω × 4, Resistor 10 kΩ × 3, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 70 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Send one signal to one of four outputs.
Parts list
- Integrated Circuits
- Switches
- SemiconductorsLED 5 mm red × 4
- PassivesResistor 220 Ω × 4
- PassivesResistor 10 kΩ × 3
- Prototyping
- Prototyping
How to build it
- Wire the select inputs to switches
- Hold the enable pin as the data line
- Show the four outputs on LEDs
- Step through all select values
- Write the truth table
Common questions
What parts do I need for the data demultiplexer?
74HC138 3-to-8 decoder, Tactile push button 6 mm × 3, LED 5 mm red × 4, Resistor 220 Ω × 4, Resistor 10 kΩ × 3, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the data demultiplexer take to build?
About 70 minutes for a beginner maker.
