Idea
In short
How do you build an electronic load with an op-amp?
An LM358 and a MOSFET hold a set current through a shunt, so you can test power supplies and batteries at exact loads. You need LM358 Op-Amp, IRFZ44N N-channel MOSFET, Shunt resistor 0.1 Ω 2 W, Potentiometer 10 kΩ, Heatsink TO-220, 12 V DC fan 80 mm, Resistor 10 kΩ, Resistor 1 kΩ, 16x2 LCD with I2C backpack (PCF8574) and Arduino Nano.
- Level
- Advanced
- Time
- About 300 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use an op-amp feedback loop to control MOSFET current.
Parts list
- Integrated Circuits
- Semiconductors
- Passives
- Passives
- Tools & Instruments
- Motors & Actuators
- Passives
- Passives
- Displays
- Development Boards
How to build it
- Set the current with the pot into the op-amp's + input
- The op-amp drives the MOSFET until the shunt voltage matches
- Current = set voltage ÷ 0.1 Ω
- Mount the MOSFET on a big heatsink with a fan
- Measure and show current and power with the Nano
Common questions
What parts do I need for the electronic load with an op-amp?
LM358 Op-Amp, IRFZ44N N-channel MOSFET, Shunt resistor 0.1 Ω 2 W, Potentiometer 10 kΩ, Heatsink TO-220, 12 V DC fan 80 mm, Resistor 10 kΩ, Resistor 1 kΩ, 16x2 LCD with I2C backpack (PCF8574) and Arduino Nano.
How long does the electronic load with an op-amp take to build?
About 300 minutes for a advanced maker.
