Idea
In short
How do you build a complementary push-pull output stage?
An NPN and a PNP transistor take turns to drive a speaker, showing how output stages work and where crossover distortion comes from. You need 2N3906 PNP transistor, NPN Transistor 2N2222, Resistor 1 kΩ × 2, Resistor 10 kΩ × 2, Speaker 8 Ω 0.5 W, 9 V battery × 2, 9 V battery snap with DC jack × 2 and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a push-pull stage.
Parts list
- Semiconductors
- Semiconductors
- PassivesResistor 1 kΩ × 2
- PassivesResistor 10 kΩ × 2
- Motors & Actuators
- Batteries9 V battery × 2
- Power
- Prototyping
How to build it
- Draw the two transistors
- Add the bias resistors
- Feed a small sine
- See the crossover notch
- Add a small bias to remove it
Common questions
What parts do I need for the complementary push-pull output stage?
2N3906 PNP transistor, NPN Transistor 2N2222, Resistor 1 kΩ × 2, Resistor 10 kΩ × 2, Speaker 8 Ω 0.5 W, 9 V battery × 2, 9 V battery snap with DC jack × 2 and Breadboard 830 Tie Points.
How long does the complementary push-pull output stage take to build?
About 180 minutes for a intermediate maker.
