Projects / Ideas / Boat bilge leak alarm

Boat bilge leak alarm

BeginnerVehiclesIdeaReviewed
In short

How do you build a boat bilge leak alarm?

A water sensor in the bottom of a model boat sounds an alarm if water collects. You need Arduino Nano, Water level sensor module, Passive buzzer, LED 5 mm red, Resistor 220 Ω, Li-Po battery 3.7 V 500 mAh and Breadboard 830 Tie Points.

Level
Beginner
Time
About 100 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Detect water and warn.

Parts list

How to build it

  1. Place the sensor low in the hull
  2. Read its level
  3. Set a threshold
  4. Beep and flash
  5. Keep electronics away from splashes

Related projects

Common questions

What parts do I need for the boat bilge leak alarm?

Arduino Nano, Water level sensor module, Passive buzzer, LED 5 mm red, Resistor 220 Ω, Li-Po battery 3.7 V 500 mAh and Breadboard 830 Tie Points.

How long does the boat bilge leak alarm take to build?

About 100 minutes for a beginner maker.