Idea
In short
How do you build a sixteen-bit bridge reader?
An ADS1115 with its programmable gain reads a small bridge signal from a strain gauge to a few microvolts. You need Arduino Nano, ADS1115 16-bit ADC module, Load cell 1 kg, INA128 instrumentation amplifier, Resistor 10 kΩ and Potentiometer 10 kΩ.
- Level
- Advanced
- Time
- About 240 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Read small differential signals accurately.
Parts list
- Development Boards
- Sensors
- Sensors
- Integrated Circuits
- Passives
- Passives
How to build it
- Amplify the bridge with the instrumentation amp
- Read differentially with a high gain
- Remove the offset
- Calibrate with known weights
- Measure the noise floor
Common questions
What parts do I need for the sixteen-bit bridge reader?
Arduino Nano, ADS1115 16-bit ADC module, Load cell 1 kg, INA128 instrumentation amplifier, Resistor 10 kΩ and Potentiometer 10 kΩ.
How long does the sixteen-bit bridge reader take to build?
About 240 minutes for a advanced maker.
