Your First PCB in KiCad: the short answer
KiCad is free, open-source and used professionally. A project has two main editors.
- Level
- Intermediate
- Time
- About 6 min
- Topic
- PCB and making
Go from schematic to a routed two-layer board in KiCad, run the checks and export Gerber and drill files.
Before this: Reading Schematics & Design Evidence, Reading a Schematic
KiCad is free, open-source and used professionally. A project has two main editors. In the schematic editor, place symbols, wire them, and give every part a value. Then assign a footprint to each symbol: the copper pad pattern for the actual part you will buy, such as an 0805 resistor or an axial through-hole resistor with 10.16 mm spacing. Check footprints against the part's datasheet; a wrong footprint is the most common reason a first board fails. Run the electrical rules check (ERC) and fix every warning you do not understand.
Update the PCB from the schematic and the parts appear in the PCB editor, connected by thin ratsnest lines. Draw the board outline on the Edge.Cuts layer. Place parts in a sensible order: connectors and mounting holes first, then the microcontroller, then its decoupling capacitors right next to its power pins, then everything else grouped by function. Route power and ground first with wide tracks (0.5 mm or more for a few hundred milliamps), then signals at about 0.25 mm. On two-layer boards, a ground fill on the bottom layer makes routing and noise much easier.
Set the design rules to your manufacturer's capabilities before you route: for example 0.15 mm minimum track and gap, 0.3 mm minimum drill and suitable annular rings. Run the design rules check (DRC) until it shows no errors and no unconnected items. Then use the 3D viewer to check placement and plot Gerbers for the copper, solder mask, silkscreen and Edge.Cuts layers, plus the drill file. Load them into a Gerber viewer, such as the one in the ElectroLark Lab, before ordering.
From schematic to board in order
The KiCad path is: draw the schematic, assign a footprint to every symbol, run the electrical rules check, update the board from the schematic, place parts, route the tracks, run the design rules check, then export manufacturing files. Skipping the rules checks is how a board with a missing connection gets ordered.
Footprints are the usual cause of trouble. Check each one against the part's datasheet land pattern and package, and print the board at full size on paper to hold the real parts against it.
Layout habits for a first board
Place connectors and mounting holes first, then the parts that must be close, such as decoupling capacitors beside the chip's power pins. Make power and ground tracks wider than signal tracks, and use a ground pour on one side. Avoid sharp corners in tracks and keep noisy tracks away from sensitive ones.
Use the manufacturer's stated minimum track width, spacing and drill size as your design rules. These are listed on their website.
Before you order
View the Gerber files in a viewer, check the board outline, silkscreen and drill holes, and check polarity marks. Add your name and a revision number on the silkscreen, so the next version can be told apart.
- Using a footprint that does not match the real part.
- Skipping the design rules check before ordering.
- Placing decoupling capacitors far from the chip's power pins.
Practise this lesson with Maker
The explanation above is free for everyone. The practice for Intermediate lessons in every domain are part of the Maker plan at ₹499 a month, and Pro includes them too.
With Maker you also get: a worked example, a hands-on task, a 3-question check.
