Real Components: Parasitics, ESR and Derating: the short answer
No component is ideal. A resistor has a little inductance from its leads and a little capacitance across its ends; a wirewound power resistor is an actual coil and can have microhenries of inductance, which matters in fast current-sense circuits.
- Level
- Advanced
- Time
- About 6 min
- Topic
- Passive components
Account for the hidden resistance, inductance and capacitance of real parts, and derate components for temperature, voltage and lifetime.
Before this: Reading and Choosing Resistors, Inductors, LC Filters and Noise, Decoupling and Bulk Capacitors
No component is ideal. A resistor has a little inductance from its leads and a little capacitance across its ends; a wirewound power resistor is an actual coil and can have microhenries of inductance, which matters in fast current-sense circuits. A capacitor has equivalent series resistance (ESR) and equivalent series inductance (ESL). Above its self-resonant frequency, a capacitor behaves like an inductor: a 100 nF ceramic in an 0603 package resonates somewhere around 10 to 30 MHz, which is why fast boards add smaller values in parallel.
ESR matters most in power circuits. Ripple current flowing through ESR makes heat (P = I² × ESR) and ripple voltage (ΔV = ΔI × ESR). An old-style general-purpose electrolytic may have an ESR of 0.5 Ω or more, while a low-ESR or polymer part can be under 0.05 Ω. Switching regulators often specify a range of output capacitor ESR for stability; some older designs need a little ESR and oscillate with very low-ESR ceramics, so follow the datasheet.
Derating means running parts below their maximum ratings so they last. Common rules: resistors at no more than about 50 to 60 % of their power rating, capacitors at no more than about 80 % of their voltage rating (tantalums at 50 %), and semiconductors well below their maximum junction temperature. Electrolytic capacitor life roughly doubles for every 10 °C cooler they run; a part rated 2,000 hours at 105 °C lasts about 16,000 hours at 75 °C. In a hot enclosure in an Indian summer, ambient can reach 45 to 50 °C, so design for it.
Every part is also something else
A real capacitor has series resistance (ESR) and series inductance (ESL), so above a certain frequency it behaves like an inductor. A real resistor has a little inductance and capacitance, and an inductor has winding resistance and capacitance between turns. These extras matter more as frequency rises.
That is why a bulk electrolytic and a small ceramic are placed together on a supply: they cover different ranges of frequency.
Derating
A part should not run at its limit. Use a capacitor voltage rating well above the working voltage, and note that the capacitance of some ceramic types, such as X5R and Y5V, falls a lot with applied DC voltage, so a 10 µF part may give half that at 5 V. A resistor should run at a fraction of its power rating, and the part temperature affects its life.
Electrolytic capacitors age faster when hot, so the life figure on the datasheet is at a stated temperature and halves roughly for every 10 °C rise.
Reading datasheets
Look for the graphs of impedance against frequency, capacitance against voltage and the ripple current rating. A quick check of the self-resonant frequency tells you the range where a part still acts as intended.
- Using a ceramic capacitor's rated value without allowing for the loss under DC bias.
- Running parts at their maximum rating with no margin.
- Ignoring ESR in a switching supply capacitor.
Practise this lesson with Pro
The explanation above is free for everyone. The practice for Advanced lessons in every domain are part of the Pro plan at ₹999 a month.
With Pro you also get: a worked example, a hands-on task, a 3-question check.
