Lab / Virtual lab / Transistors

CE amplifier frequency response

Plot the gain of a common-emitter stage against frequency and find the mid-band gain and the low cut-off set by the coupling capacitor.

TransistorsSimulated

Circuit

Updates as you change values
RCRC 4.7 kΩ, RL 10 kΩ12 V10 mV sine, CC 1 µF

A BJT stage biased at IC = 1 mA, RC = 4.7 kΩ, source resistance 1 kΩ; a coupling capacitor in and a load RL out. Read the output for a 10 mV sine at each frequency.

Controls

Changing any setting except frequency starts a new set of readings.

Meters

Frequency1000 Hz
Output (10 mV in)983 mV
Gain39.8 dB

Graph

0 readings

Your graph appears here

Take readings, or press Auto sweep to log a full set.

your readings

Theory

  • gm = IC / VT = 1 mA / 25.85 mV ≈ 38.7 mS, rπ = β / gm
  • Mid-band gain AM = −gm (RC ∥ RL) × rπ / (RS + rπ)
  • Low cut-off fL = 1 / (2π (RS + rπ) CC): the coupling capacitor blocks low frequencies
  • High cut-off fH comes from transistor capacitance and the Miller effect (about 500 kHz here)
  • Bandwidth ≈ fH − fL; gain × bandwidth is roughly constant for a given transistor

Worked out for your values

gm
0.03868 S
rπ
3.878 kΩ
Mid-band gain
98.3 (39.9 dB)
Low cut-off fL
32.63 Hz
High cut-off fH
500 kHz

Your result

Worked out from your readings and compared with theory.

Mid-band gain

Take readings in the flat part of the curve.

Low cut-off fL (gain 3 dB below mid-band)

Take readings either side of the low cut-off.

Sources of error

  • Bypass and coupling capacitors each add their own low cut-off
  • Source and load resistances change the mid-band gain
  • Read the output on the scope, not the meter, at high frequency; probe capacitance lowers fH