Wien bridge oscillator
To design and test a Wien bridge oscillator and measure its frequency.
- IC 741
- Resistors 10 kΩ × 2 (bridge), Rf and R1 for gain
- Capacitors 0.01 µF × 2
- Dual supply ±12 V
- CRO
Theory
The Wien network (series RC and parallel RC) has zero phase shift at f = 1/(2πRC) and passes one-third of the signal there. A non-inverting amplifier with gain 3 (Rf = 2R1) keeps oscillation going. In practice the gain is set slightly above 3, and a lamp, diodes or a JFET stabilise the amplitude.
- Output → series R and C → pin 3; parallel R and C from pin 3 to ground; Rf from pin 6 to 2, R1 from pin 2 to ground
Procedure
Pre-lab check
4 questions · 75% to be readyTry the readings before the lab
| Quantity | Value |
|---|---|
| f = 1 / (2πRC) | 1 kHz |
| Required gain | 3 (Rf = 2·R1) |
Precautions
- Too much gain gives a clipped, square-ish output; too little and it stops.
My readings
Type what you measured. It goes into your record book, and to My Garage when you are signed in.
| S. No. | Quantity | Value |
|---|---|---|
| 1 | ||
| 2 | ||
| 3 | ||
| 4 | ||
| 5 | ||
| 6 |
Check my readings
Put the value you set in the first column, then compare. Real parts have tolerance.
Designed frequency ___ Hz, measured ___ Hz.
Everything above is free. The print-ready write-up comes with Maker.
Printed pages leave the observation table empty for your own readings.
Viva questions
Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.
Quick answers for your record and viva
What is the aim of the wien bridge oscillator experiment?
To design and test a Wien bridge oscillator and measure its frequency.
What apparatus is needed for wien bridge oscillator?
IC 741, Resistors 10 kΩ × 2 (bridge), Rf and R1 for gain, Capacitors 0.01 µF × 2, Dual supply ±12 V, CRO.
What is the theory behind wien bridge oscillator?
The Wien network (series RC and parallel RC) has zero phase shift at f = 1/(2πRC) and passes one-third of the signal there. A non-inverting amplifier with gain 3 (Rf = 2R1) keeps oscillation going. In practice the gain is set slightly above 3, and a lamp, diodes or a JFET stabilise the amplitude.
What result should I get in wien bridge oscillator?
Designed frequency ___ Hz, measured ___ Hz.
What precautions should I take in wien bridge oscillator?
Too much gain gives a clipped, square-ish output; too little and it stops.
