Lab / VTU / Analog and linear ICs / Experiment 12

555 timer as a monostable multivibrator

Analog and linear ICsVirtual readings4 viva questionsRecord book ready
Open virtual bench
Aim

To build a 555 monostable multivibrator and verify the pulse width T = 1.1RC.

Apparatus
  • IC NE555
  • Resistor R, capacitor C
  • Push button with 10 kΩ pull-up
  • DC supply
  • CRO or LED
555

Theory

A falling edge on the trigger (pin 2) below ⅓Vcc sets the output high and lets C charge through R. When the capacitor reaches ⅔Vcc, the output returns low and C discharges. The pulse width is T = 1.1RC, independent of the supply voltage.

Circuit connections
  • R from Vcc to pins 6 and 7, C from pins 6 and 7 to ground
  • Trigger: pin 2 held high by 10 kΩ, pulled low by the button

Procedure

Pre-lab check

4 questions · 75% to be ready
1What is a monostable multivibrator?
2Does the pulse width depend on Vcc?
3Name uses of a monostable 555.
4What happens if you trigger again during the pulse?

Try the readings before the lab

Calculated, not measured. In the lab, write down your own readings.
QuantityValue
T = 1.1RC1.1 s

Precautions

  • The trigger pulse must be shorter than T.
  • Use a capacitor with low leakage for long delays.

My readings

Type what you measured. It goes into your record book, and to My Garage when you are signed in.

S. No.QuantityValue
1
2
3
4
5
6

Check my readings

Put the value you set in the first column, then compare. Real parts have tolerance.

Open my record book
Result

Designed T = ___ s, measured T = ___ s.

Everything above is free. The print-ready write-up comes with Maker.

Printed pages leave the observation table empty for your own readings.

Viva questions

Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.

1. What is a monostable multivibrator?
2. Does the pulse width depend on Vcc?
3. Name uses of a monostable 555.
4. What happens if you trigger again during the pulse?

Quick answers for your record and viva

What is the aim of the 555 timer as a monostable multivibrator experiment?

To build a 555 monostable multivibrator and verify the pulse width T = 1.1RC.

What apparatus is needed for 555 timer as a monostable multivibrator?

IC NE555, Resistor R, capacitor C, Push button with 10 kΩ pull-up, DC supply, CRO or LED.

What is the theory behind 555 timer as a monostable multivibrator?

A falling edge on the trigger (pin 2) below ⅓Vcc sets the output high and lets C charge through R. When the capacitor reaches ⅔Vcc, the output returns low and C discharges. The pulse width is T = 1.1RC, independent of the supply voltage.

What result should I get in 555 timer as a monostable multivibrator?

Designed T = ___ s, measured T = ___ s.

What precautions should I take in 555 timer as a monostable multivibrator?

The trigger pulse must be shorter than T. Use a capacitor with low leakage for long delays.

555 timer as a monostable multivibrator: lab experiment