W5500 Ethernet module
Wired Ethernet with a hardware TCP/IP stack over SPI.
RadioWired 10/100 Ethernet
InterfaceSPI
Supply voltage3.3 V (5 V tolerant I/O)
WirelessReviewedMPN W5500Used in 2 projects
In short
What is the W5500 Ethernet module and what is it used for?
Wired Ethernet with a hardware TCP/IP stack over SPI. Makers use it for wired IoT and web servers.
How it works
A WIZnet W5500 with a full hardware TCP/IP stack, 8 sockets and a 10/100 Ethernet PHY.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | Wired 10/100 Ethernet |
| Interface | SPI |
| Supply voltage | 3.3 V (5 V tolerant I/O) |
Pinout
3.3V3.3 V (some boards have a 5 V pin)
GNDGround
MOSI MISO SCKSPI
CS (SCS)Chip select
RSTReset
INTInterrupt
How to use it
The standard Arduino Ethernet library supports the W5500. Call Ethernet.init(csPin) before Ethernet.begin(mac). I/O pins are 5 V tolerant.
Applications
Wired IoT and web servers
Builds that use it
Alternatives
- ENC28J60 Ethernet moduleOlder and needs a software stack
- Arduino Ethernet Shield W5100 / W5500Shield form with SD slot
Common questions
What is the W5500 Ethernet module used for?
In maker projects: wired IoT and web servers.
How does the W5500 Ethernet module work?
A WIZnet W5500 with a full hardware TCP/IP stack, 8 sockets and a 10/100 Ethernet PHY.
What voltage does the W5500 Ethernet module need?
3.3 V (5 V tolerant I/O).
How do I connect the W5500 Ethernet module to an Arduino or ESP32?
SPI. Pins: 3.3V (3.3 V (some boards have a 5 V pin)), GND (Ground), MOSI MISO SCK (SPI), CS (SCS) (Chip select), RST (Reset), INT (Interrupt).
What can I use instead of the W5500 Ethernet module?
ENC28J60 Ethernet module and Arduino Ethernet Shield W5100 / W5500.
