ENC28J60 Ethernet module
Older SPI Ethernet chip. Needs a software TCP/IP stack.
RadioWired 10 Mbps Ethernet
InterfaceSPI
Supply voltage3.3 V
WirelessReviewedMPN ENC28J60Used in 2 projects
In short
What is the ENC28J60 Ethernet module and what is it used for?
Older SPI Ethernet chip. Needs a software TCP/IP stack. Makers use it for budget wired networking.
How it works
A Microchip 10 Mbps Ethernet controller with an SPI interface.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | Wired 10 Mbps Ethernet |
| Interface | SPI |
| Supply voltage | 3.3 V |
Pinout
VCC3.3 V, about 180 mA
GNDGround
SCK SI SO CSSPI
RSTReset
INTInterrupt
How to use it
It has no hardware TCP/IP stack, so it needs the UIPEthernet or EtherCard library, which uses much of an Uno's RAM. Choose the W5500 for new designs.
Applications
Budget wired networking
Alternatives
- W5500 Ethernet moduleHardware TCP/IP, faster
Common questions
What is the ENC28J60 Ethernet module used for?
In maker projects: budget wired networking.
How does the ENC28J60 Ethernet module work?
A Microchip 10 Mbps Ethernet controller with an SPI interface.
What voltage does the ENC28J60 Ethernet module need?
3.3 V.
How do I connect the ENC28J60 Ethernet module to an Arduino or ESP32?
SPI. Pins: VCC (3.3 V, about 180 mA), GND (Ground), SCK SI SO CS (SPI), RST (Reset), INT (Interrupt).
What can I use instead of the ENC28J60 Ethernet module?
W5500 Ethernet module.
