Components / Wireless / SX1276 LoRa Module

SX1276 LoRa Module

LoRa-capable radio module family subject to band and regional restrictions.

RadioLoRa and FSK transceiver
Band868 MHz or 915 MHz versions (India uses 865 to 867 MHz)
Typical rangeSeveral km line of sight; hundreds of metres in a city
InterfaceSPI plus DIO0 interrupt and RESET
WirelessReviewedMPN SX1276 / RFM95WUsed in 2 projects
SX1276
In short

What is the SX1276 LoRa Module and what is it used for?

LoRa-capable radio module family subject to band and regional restrictions. Makers use it for understand SPI and RF compliance.

Check your country's rules for the band and duty cycle before deploying.
In the real world

Remote sensor networks

How it works

RF modules require power, antenna/interface matching and local wireless regulatory compliance.

Key specifications

Wireless module specValue
RadioLoRa and FSK transceiver
Band868 MHz or 915 MHz versions (India uses 865 to 867 MHz)
Typical rangeSeveral km line of sight; hundreds of metres in a city
InterfaceSPI plus DIO0 interrupt and RESET
Supply voltage1.8 to 3.7 V
Logic level3.3 V only

Pinout

3.3V / GNDPower
SCK, MISO, MOSI, NSSSPI
RESETReset
DIO0Packet done interrupt
ANTAntenna: always fit one before transmitting

How to use it

Buy the band allowed where you use it and never transmit without an antenna. Data rates are low (bytes per second to a few kbps), so send small readings.

#include <LoRa.h>
void setup() { LoRa.setPins(5, 14, 2); LoRa.begin(866E6); }
void loop() { LoRa.beginPacket(); LoRa.print("temp=27.4"); LoRa.endPacket(); delay(10000); }

Applications

Alternatives

Buy at

Common questions

What is the SX1276 LoRa Module used for?

In products: remote sensor networks. In maker projects: understand SPI and RF compliance.

How does the SX1276 LoRa Module work?

RF modules require power, antenna/interface matching and local wireless regulatory compliance.

What voltage does the SX1276 LoRa Module need?

1.8 to 3.7 V.

How do I connect the SX1276 LoRa Module to an Arduino or ESP32?

SPI plus DIO0 interrupt and RESET. Pins: 3.3V / GND (Power), SCK, MISO, MOSI, NSS (SPI), RESET (Reset), DIO0 (Packet done interrupt), ANT (Antenna: always fit one before transmitting).

What can I use instead of the SX1276 LoRa Module?

nRF24L01+ Radio Module.