RAK3172 LoRaWAN module
STM32WL module with LoRa built in, controlled by AT commands.
RadioLoRa / LoRaWAN
BandIN865
InterfaceUART
Supply voltage2.0 to 3.6 V
WirelessReviewedMPN RAK3172Used in 2 projects
In short
What is the RAK3172 LoRaWAN module and what is it used for?
STM32WL module with LoRa built in, controlled by AT commands. Makers use it for loRaWAN sensor nodes.
How it works
An STM32WLE5 chip with a built-in LoRa radio and the LoRaWAN stack.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | LoRa / LoRaWAN |
| Band | IN865 |
| Interface | UART |
| Supply voltage | 2.0 to 3.6 V |
Pinout
VDD2.0 to 3.6 V
UART2 TX RXAT commands
SWDIO SWCLKProgramming
RFAntenna pad
BOOTBootloader
How to use it
Talk to the stock RUI3 firmware with AT commands: set the region to IN865, enter your DevEUI, AppEUI and AppKey, and join. You can also program it directly with RUI3 in the Arduino IDE.
Applications
LoRaWAN sensor nodes
Alternatives
- RFM95W LoRa module (868 MHz)Raw SX1276 over SPI
- E32 LoRa UART module (868 MHz)Point-to-point serial link
Common questions
What is the RAK3172 LoRaWAN module used for?
In maker projects: loRaWAN sensor nodes.
How does the RAK3172 LoRaWAN module work?
An STM32WLE5 chip with a built-in LoRa radio and the LoRaWAN stack.
What voltage does the RAK3172 LoRaWAN module need?
2.0 to 3.6 V.
How do I connect the RAK3172 LoRaWAN module to an Arduino or ESP32?
UART. Pins: VDD (2.0 to 3.6 V), UART2 TX RX (AT commands), SWDIO SWCLK (Programming), RF (Antenna pad), BOOT (Bootloader).
What can I use instead of the RAK3172 LoRaWAN module?
RFM95W LoRa module (868 MHz) and E32 LoRa UART module (868 MHz).
