NRF24L01+ PA LNA with antenna
NRF24L01+ with a power amplifier and external antenna for longer range.
What is the NRF24L01+ PA LNA with antenna and what is it used for?
NRF24L01+ with a power amplifier and external antenna for longer range. Makers use it for long-range RC and telemetry.
A Nordic nRF24L01+ with a power amplifier and low-noise amplifier that sends acknowledged packets at 250 kbps to 2 Mbps.
Key specifications
| Wireless module spec | Value |
|---|---|
| Radio | Nordic Enhanced ShockBurst |
| Band | 2.4 GHz |
| Typical range | Up to about 1 km line of sight |
| Interface | SPI |
| Supply voltage | 3.3 V, peaks above 100 mA (add a 10 µF capacitor) |
| Logic level | 5 V tolerant inputs |
Pinout
How to use it
Use the RF24 library and an adapter board with its own 3.3 V regulator, or add a 10 µF to 100 µF capacitor across VCC and GND. Set radio.setPALevel(RF24_PA_LOW) when testing on a desk, because full power overloads a nearby receiver.
Applications
Builds that use it
Alternatives
- nRF24L01+ Radio ModuleShort-range version with a PCB antenna
- LoRa SX1278 Ra-02 module (433 MHz)Kilometres of range at low data rates
Common questions
What is the NRF24L01+ PA LNA with antenna used for?
In maker projects: long-range RC and telemetry.
How does the NRF24L01+ PA LNA with antenna work?
A Nordic nRF24L01+ with a power amplifier and low-noise amplifier that sends acknowledged packets at 250 kbps to 2 Mbps.
What voltage does the NRF24L01+ PA LNA with antenna need?
3.3 V, peaks above 100 mA (add a 10 µF capacitor).
How do I connect the NRF24L01+ PA LNA with antenna to an Arduino or ESP32?
SPI. Pins: GND (Ground), VCC (3.3 V only), CE (Chip enable (pin 9 on Uno in examples)), CSN (SPI chip select (pin 10)), SCK (SPI clock), MOSI (SPI data in).
What can I use instead of the NRF24L01+ PA LNA with antenna?
nRF24L01+ Radio Module and LoRa SX1278 Ra-02 module (433 MHz).
