Components / Sensors / Capacitive Soil Moisture Module

Capacitive Soil Moisture Module

Measures changes in soil-related capacitance for estimated moisture.

MeasuresSoil moisture (relative)
RangeRaw analog; calibrate dry and wet
AccuracyRelative only; depends on soil and calibration
InterfaceAnalog voltage out
SensorsReviewedMPN Capacitive v1.2 (SEN0193-style)Used in 18 projects
CAPACITI
In short

What is the Capacitive Soil Moisture Module and what is it used for?

Measures changes in soil-related capacitance for estimated moisture. Makers use it to log and calibrate moisture readings.

Some clones are missing the voltage regulator or use the wrong timer chip, which makes them read strangely on 3.3 V. Calibrate yours.
In the real world

Plant-monitoring automation

How it works

Sensors convert a physical quantity into an electrical signal. Calibrate, verify module supply, interfaces and environmental limits.

Key specifications

Sensor specValue
MeasuresSoil moisture (relative)
RangeRaw analog; calibrate dry and wet
AccuracyRelative only; depends on soil and calibration
InterfaceAnalog voltage out
Supply voltage3.3 to 5.5 V
Operating temperature0 to 60 °C

Pinout

VCC3.3 or 5 V
GNDGround
AOUTAnalog output: lower when wetter

How to use it

Read it in air (dry) and in a glass of water (wet), then map between them. Do not push it in past the line, and seal the top edge and electronics against water.

const int DRY = 2900, WET = 1250;
void setup() { Serial.begin(115200); }
void loop() { int raw = analogRead(34); Serial.println(map(raw, DRY, WET, 0, 100)); delay(1000); }

Applications

Buy at

Common questions

What is the Capacitive Soil Moisture Module used for?

In products: plant-monitoring automation. In maker projects: log and calibrate moisture readings.

How does the Capacitive Soil Moisture Module work?

Sensors convert a physical quantity into an electrical signal. Calibrate, verify module supply, interfaces and environmental limits.

What voltage does the Capacitive Soil Moisture Module need?

3.3 to 5.5 V.

How do I connect the Capacitive Soil Moisture Module to an Arduino or ESP32?

Analog voltage out. Pins: VCC (3.3 or 5 V), GND (Ground), AOUT (Analog output: lower when wetter).