Tools / Zener Series Resistor
How to work out a Zener diode resistor
The resistor carries the load current plus a little for the Zener, and drops the extra voltage. Here is the working with your numbers.
R = (Vin − Vz) / (Iload + Iz)
Result
- Series resistor
- 460 Ω
- Resistor power
- 103.5 mW
- Zener power w no load
- 0.0765
What this leaves out
- Zener dissipation with the load removed is the worst case; use a regulator for anything sensitive.
Step by step
The working with your numbers
- Find the voltage across the resistor
V_R = Vin − Vz = 12 − 5.1 = 6.9 V - Add the load current and the Zener's minimum current
I = 10 + 5 = 15 mA = 0.015 AThe Zener needs a few mA of its own to stay in regulation. - Use Ohm's law
R = V_R ÷ I = 6.9 ÷ 0.015 = 460 Ω - Heat in the resistor
P_R = V_R² ÷ R = 6.9² ÷ 460 = 103 mW - Worst-case heat in the Zener (load unplugged)
P_Z = Vz × V_R ÷ R = 5.1 × 6.9 ÷ 460 = 76.5 mW
Does the answer make sense?
- OK: Check it backwards: 6.9 V ÷ 460 Ω = 15 mA, enough for the load and the Zener.
- OK: 76.5 mW is safe for a 0.5 W Zener.
- OK: If your supply varies (say 9 to 12 V), work out R at the lowest supply and check the power at the highest.
Pick a real part
- Go down to the next standard (E12) value, 390 Ω, so the Zener keeps at least its minimum current.
- 390 Ω dissipates 122 mW, so use a 1/4 W resistor.
- Zener with no load: 90.2 mW, so choose a Zener rated 0.5 W or more.
Common mistakes
- Sizing the resistor for the load only. Without the Zener's own few mA it drops out of regulation.
- Checking the Zener's power with the load connected. The worst case is with the load unplugged, when all the current goes through the Zener.
- Rounding the resistor up. That cuts the current, so round down.
Learn it, try it, build it
Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.
Just need the number? Use the zener series resistor calculator on Geekobot.
Common questions
How do you work out a Zener diode resistor?
R = (Vin − Vz) ÷ (load current + Zener minimum current). For 12 V to a 5.1 V Zener feeding 10 mA plus 5 mA for the Zener: 6.9 ÷ 0.015 = 460 Ω, so use 390 Ω.
When is a Zener diode under the most stress?
When the load is unplugged. All the resistor's current then flows through the Zener, so check its power rating for that case.
