Tools / Thevenin and Norton equivalent

How to find a Thevenin and Norton equivalent

Any linear network seen from two terminals acts like one voltage source with one resistor. Find those two numbers and the load is easy.

Vth = Vs × R2 ÷ (R1 + R2); Rth = (R1 ∥ R2) + R3; IN = Vth ÷ Rth; IL = Vth ÷ (Rth + RL)

Inputs

V
Ω
Ω
Ω
Ω

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Thevenin voltage
8.25 V
Thevenin resistance
1.158 kΩ
Norton current
7.127 mA
Load current
3.824 mA
Load voltage
3.824 V
Load power
14.62 mW
Max power load
1.158 kΩ
Max power
14.7 mW
Step by step

The working with your numbers

  1. Take the load off and find the open-circuit voltageVth = Vs × R2 ÷ (R1 + R2) = 12 × 2,200 ÷ (1,000 + 2,200) = 8.25 VWith no load, no current flows in R3, so there is no drop across it.
  2. Replace the source by a short and find the resistance at the terminalsRth = (R1 ∥ R2) + R3 = 688 Ω + 470 = 1.16 kΩR1 and R2 end up in parallel with each other; R3 is in series with them.
  3. Norton currentIN = Vth ÷ Rth = 8.25 V ÷ 1.16 kΩ = 7.13 mAThe short-circuit current at the terminals.
  4. Put the load back on the equivalentIL = Vth ÷ (Rth + RL) = 8.25 V ÷ (1.16 kΩ + 1,000) = 3.82 mA
  5. Load voltage and powerVL = IL × RL = 3.82 V, P = IL² × RL = 14.6 mW

Does the answer make sense?

  • OK: Check against the original circuit: solving it directly gives the same 3.82 mA through the load.
  • OK: The load gets the most power when RL equals Rth (1.16 kΩ): 14.7 mW, but only half of the source's power reaches it.
  • OK: The load is comparable to Rth, so the source sags noticeably under it.

Common mistakes

  • Leaving the load connected when you measure Vth. It must be the open-circuit voltage.
  • Forgetting to switch the source off (replace it by a short) before finding Rth.
  • Using the Norton current as if it were the load current. It is the current into a short, not into RL.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How do you find the Thevenin equivalent of a circuit?

Remove the load and find the open-circuit voltage across the terminals (Vth). Then replace each voltage source by a short, each current source by an open circuit, and find the resistance between the terminals (Rth).

How is the Norton equivalent related to the Thevenin one?

They are the same source in two forms: Rn = Rth and In = Vth ÷ Rth. The Norton current is what flows if you short the terminals.

When does a load get maximum power?

When the load resistance equals the Thevenin resistance. Then P = Vth² ÷ (4 × Rth), and half the power is lost inside the source.