Tools / RL time constant

How to work out an RL time constant

An inductor fights any change in current, so the current climbs gradually. L ÷ R says how gradually.

τ = L ÷ R; I(t) = (V ÷ R)(1 − e^(−t/τ)); E = ½LI²

Inputs

V
Ω
mH

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Time constant
1 ms
Settling time
5 ms
Final current
50 mA
Stored energy
125 µJ
Step by step

The working with your numbers

  1. Change the inductance to henriesL = 100 mH ÷ 1000 = 0.1 H
  2. Divide L by Rτ = L ÷ R = 0.1 ÷ 100 = 1 msIn an RL circuit the larger R is, the faster the current settles.
  3. The current heads for V ÷ RI(final) = 5 ÷ 100 = 50 mAAt the end the inductor behaves like a plain wire.
  4. After one τ it has reached 63 %31.6 mA at 1 ms, 95 % (47.5 mA) at 3τ = 3 ms, full at 5τ = 5 ms
  5. Energy stored in the fieldE = ½ × L × I² = 0.5 × 0.1 × 0.05² = 125 µJ

Does the answer make sense?

  • OK: Units check: henries ÷ ohms = seconds. Doubling L doubles τ to 2 ms.
  • Watch out: Switching off is the danger. The coil tries to keep 50 mA flowing, so the switch sees a large spike. Put a diode across a relay or motor coil, and pick a diode rated for at least 50 mA.

Common mistakes

  • Using RC instead of L ÷ R. For an inductor, a bigger resistor makes it faster, the opposite of a capacitor.
  • Forgetting the coil's own winding resistance. Add it to R, especially for relay and motor coils.
  • Opening a switch on a coil with no diode. The spike can be hundreds of volts.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How do you work out an RL time constant?

τ = L ÷ R, with L in henries and R in ohms. 100 mH and 100 Ω give 0.1 ÷ 100 = 1 ms. After one τ the current is at 63 % of V ÷ R.

Why does a bigger resistor make an RL circuit faster?

The final current V ÷ R is smaller, so the inductor has less energy to build up and reaches it sooner. The time constant L ÷ R shrinks as R grows.