Tools / Rectifier ripple and filter capacitor
How to work out rectifier ripple and the filter capacitor
The capacitor tops up the peaks and the load drains it between them. The ripple is how much it drops each time.
Vpk = Vrms√2 − diode drops; Vripple ≈ I ÷ (f_r × C); C = I ÷ (f_r × Vripple)
Result
- Peak voltage
- 11.33 V
- Ripple voltage
- 909.1 mV
- Minimum voltage
- 10.42 V
- Average voltage
- 10.87 V
- Ripple of average
- 8.361 %
- Required capacitance
- 2 mF
- Diode reverse voltage
- 12.73 V
Step by step
The working with your numbers
- Peak of the AC (rms × √2)
9 × 1.414 = 12.7 V - Take off the diode drops (two diodes conduct at a time)
Vpk = 12.7 − 1.4 = 11.3 V - Ripple frequency
Full-wave: f_r = 2 × 50 = 100 HzA bridge refills the capacitor twice per mains cycle, so it has half the ripple of a half-wave. - Ripple (peak to peak)
Vr = I ÷ (f_r × C) = 0.2 ÷ (100 × 0.0022) = 0.909 V - The output swings between
10.4 V and 11.3 V, average about 10.9 V - Capacitor for only 1 V of ripple
C = I ÷ (f_r × Vr) = 0.2 ÷ (100 × 1) = 2 mF
Does the answer make sense?
- OK: Ripple is 8.03 % of the peak. The straight-line estimate holds.
- OK: The lowest voltage is 10.4 V. A regulator needs its dropout (about 2 V for a 7805) above its output at this low point.
Pick a real part
- Pick the next standard value up: 2200 µF, rated at least 1.5 × 11.3 V (17 V), so a 25 V or 35 V part.
- Diode: reverse rating above 12.7 V, current above 600 mA to survive the charging pulses. A 1N4007 fits low-current supplies.
- Electrolytics are −20 % to +80 %, so the real ripple can be about 25 % higher than calculated.
Common mistakes
- Using the rms voltage as if it were the DC. The capacitor charges to the peak, which is 41 % higher, minus the diodes.
- Forgetting that a bridge has two diode drops, 1.4 V in total.
- Using the load current at idle. Size the capacitor for the largest current the supply must give.
Learn it, try it, build it
Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.
Common questions
How do you work out the ripple voltage of a rectifier?
Vripple ≈ I ÷ (f_r × C), with f_r the ripple frequency: the mains frequency for half-wave, twice that for full-wave. 200 mA, 100 Hz and 2200 µF give 0.2 ÷ (100 × 0.0022) ≈ 0.91 V peak to peak.
How big should the filter capacitor be?
C = I ÷ (f_r × Vripple). For 200 mA, a 100 Hz ripple and 1 V allowed ripple that is 2000 µF, so use the next standard value up, 2200 µF.
