Idea
In short
How do you build an USB cable data tester?
A small jig checks whether a USB cable has data wires, how much resistance each wire has and how the voltage drops under a small load. You need USB A to USB-C cable (data), USB A to micro-USB cable (data), Arduino Nano, Micro USB breakout board, Resistor 10 kΩ × 2, Resistor 330 Ω and Digital multimeter.
- Level
- Beginner
- Time
- About 120 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Test USB cables.
Parts list
- Cables & Wires
- Cables & Wires
- Development Boards
- Connectors
- PassivesResistor 10 kΩ × 2
- Passives
- Tools & Instruments
How to build it
- Break out the four wires
- Test continuity of each
- Measure wire resistance
- Add a small load and measure the drop
- Try a board upload through it
Common questions
What parts do I need for the USB cable data tester?
USB A to USB-C cable (data), USB A to micro-USB cable (data), Arduino Nano, Micro USB breakout board, Resistor 10 kΩ × 2, Resistor 330 Ω and Digital multimeter.
How long does the USB cable data tester take to build?
About 120 minutes for a beginner maker.
