Idea
In short
How do you build a transistor H-bridge?
Build a motor direction circuit from two NPN and two PNP transistors and see why the diodes matter. You need Arduino Nano, S8050 NPN transistor × 2, S8550 PNP transistor × 2, Resistor 1 kΩ × 4, Rectifier Diode 1N4007 × 4, BO motor L-type 150 RPM, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 270 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build an H-bridge from parts.
Parts list
- Development Boards
- Semiconductors
- Semiconductors
- PassivesResistor 1 kΩ × 4
- Semiconductors
- Motors & Actuators
- Batteries
- Power
- Prototyping
How to build it
- Draw the bridge
- Wire the low side
- Wire the high side
- Add the diodes
- Test both directions
Common questions
What parts do I need for the transistor H-bridge?
Arduino Nano, S8050 NPN transistor × 2, S8550 PNP transistor × 2, Resistor 1 kΩ × 4, Rectifier Diode 1N4007 × 4, BO motor L-type 150 RPM, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the transistor H-bridge take to build?
About 270 minutes for a intermediate maker.
