Idea
In short
How do you build a height-hold bench model?
A lidar sensor and a small motor on a string model how a drone holds its height, tested on a bench with a guard. No flying parts. You need Arduino Nano, TFmini-S LiDAR, 5 V DC fan 40 mm, MOSFET IRLZ44N, Rectifier Diode 1N4007, Potentiometer 10 kΩ, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
- Level
- Advanced
- Time
- About 330 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn height control on a safe bench model.
Parts list
- Development Boards
- Sensors
- Motors & Actuators
- Semiconductors
- Semiconductors
- Passives
- Power
- Prototyping
How to build it
- Read the height
- Drive a fan with a MOSFET
- Hold a light ball at a height
- Tune a simple controller
- Add a safe stop
Common questions
What parts do I need for the height-hold bench model?
Arduino Nano, TFmini-S LiDAR, 5 V DC fan 40 mm, MOSFET IRLZ44N, Rectifier Diode 1N4007, Potentiometer 10 kΩ, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
How long does the height-hold bench model take to build?
About 330 minutes for a advanced maker.
