Projects / Ideas / Text over a torch beam

Text over a torch beam

IntermediateCommunicationIdeaReviewed
In short

How do you build a text over a torch beam?

A Nano flashes an LED in a pattern that carries a short text message, and a second Nano with a light sensor across the room reads the flashes and prints the text. It is a tiny light link, like fibre-optic internet without the fibre. Do not point bright LEDs at eyes. You need Arduino Nano × 2, LED 5 mm red, Resistor 220 Ω, Phototransistor L14F1 / PT333, Resistor 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Send a short message with flashes of light.

Parts list

How to build it

  1. Choose a flash rate and a start pattern
  2. Send each letter as bits
  3. Read the sensor on the second board
  4. Rebuild the letters
  5. Test the longest distance that still works

Related projects

Common questions

What parts do I need for the text over a torch beam?

Arduino Nano × 2, LED 5 mm red, Resistor 220 Ω, Phototransistor L14F1 / PT333, Resistor 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the text over a torch beam take to build?

About 100 minutes for a intermediate maker.